Case:
Customers said that when the computer host is turned on, the motherboard’s BIOS can recognize the model of the hard disk, and the capacity of the hard disk is normal, but it cannot enter the Windows operating system.After that, the customer mounted the hard disk directly into a board. Under the Windows operating system, it was prompted to identify the hard disk model, but it was still impossible to see any partition.Mainly restore all partitions after C drive, as well as the data of the desktop C drive, the data in my document and other folders.
Solution:
The engineer of the Data Recovery Center first detected the hard disk through the information provided by the customer through the information provided by the customer, and found that the device identified the hard disk model is normal.First enter the PC3000 UDMA WD special mode, all the firmware of the backup hard disk, and during the process of backup modules, it is prompted to damage the design of the hard disk, and other firmware backups are normal. The preliminary judgment of the rescue data recovery engineer is caused by the firmware damage.The engineer of the Data Recovery Center fixes the decoded table of the hard disk through professional equipment PC3000 UDMA, and then opens the PC3000 UDMA de process.success.