Case:A disk of the customer company server has been damaged. After the dust is cleaned up, the hard disk is inserted again, causing the array information to be lost. Solution:Calculate the BLOC SIZE parameter, re -set up a virtual array, calculate all partition areas, all the data is restored, and the data recovers 100%.
Case:Customers’ desktop computer suddenly appeared to be unable to enter the system under normal use, and the Seagate 500GB desktop hard disk was found to be found to be identified by the computer. Solution:First detect whether it is a firmware problem, enter the instruction, cut off the electrometer at the level 1, and then lift…
Case:The client’s 10 -generation hard disk cannot be recognized, and the “Celog36″” error is constantly jumping out under the instruction. Solution:The CELOG error currently understood is divided into two cases
Case:Customer laptop has been used normally before, and suddenly unable to turn on, so I took the laptop maintenance station for maintenance. The inspection found that it was a hard disk failure. The customer’s hard disk data was very important, and the data was urgently needed to restore the data. Solution:The customer’s notebook is Seagate…
Case:Customers have taken a hard disk of Seagate’s 160GB today, saying that the hard disk has no response to power. It has been the same for receiving other computers. Solution:First judge that there may be problems with the circuit board, or if the firmware is damaged.Then simplify the difficult method, first change the circuit board,…
Case:Customers took a hard disk recovery data of Seagate’s 500GB, saying that they could not enter the operating system, and they were crashing in PE. Solution:There is a problem with this self -inspection. After I barely detected it, I asked the customer which partition, 5 partitions in the hard disk.In the mirror image, 20%of the…
Case:Customers took a Seagate ST380211AS hard disk to restore the data, saying that the hard disk had abnormal noise in the disk. Solution:After testing, the magnetic head could not be reset at all, and the instruction reported that it was similar to “Head Mask””. It seemed that there was a problem with the magnetic head.The…
Case:The Customer’s Seagate hard disk cannot be recognized, but the sound of magnetic head reset is normal. Solution:First of all, 3K found that the magnetic head can be reset normally. Because there is a preparation on hand, the circuit board replacement work is performed (a large part of the 7th generation disk is caused by…
Case:Customer Kingston U disk was lost due to hot insertion data. Solution:After the customer U disk is connected to the computer, the use space is displayed to 0. When it is turned on, it is prompted to “not format””. Use Winhex to open the U disk. It is found that the partition starts without DBR
Case:The client said that the mobile hard disk was used yesterday, and some data were copied to the mobile hard disk.Today, I found that the mobile hard disk was received on the computer, and the computer was stuck, and the indicator of the mobile hard disk was always flashing.Hope to rescue all the data in…
